These instructions are aimed at the end-user who has just purchased a building that included a Union Micro elevator pre-installed. These instructions will be quite brief due to the fact that most of the dirty work has already been done – you just have to touch a few buttons to get everything working.
- First things first – you need an Elevator Unlocker to activate your elevator. You may purchase one of these at Union Micro if you don’t already have one. If you need help with the Elevator Unlocker, please see the Elevator Unlocker instructions.
- After you’ve input your serial number into your elevator car, you will need to find out where the builder has positioned the elevator controller in the building.
Elevator controllers look like this (assuming the builder has not modified it):
- After you’ve found the controller, simply touch it to bring up its menu. From the menu choose “Hard Reset” – this will reset all of your elevator parts in case anything odd has happened to them while being rezzed and positioned. You should see a white progress bar appear on all of your elevator parts. Wait until the doors on each floor have finished loading before proceeding to the next step.
- Touch your controller again and this time choose “Set Floors” from its menu. This tells all of your doors to talk to each other and figure out which floor they’re on. This step should complete after about 10 seconds – the doors will whisper “My floor is now set to: X” when finished.
- Locate your car and get your camera inside of it. Touch the no-smoking sign and choose “Install” from its menu. Assuming the builder has positioned everything properly, your serial number is valid, and there are no stray prims in the shaft, the car will load its settings and start moving.
If you encounter any problems you should contact the builder of the building and not Union Micro. You may also wish to look at the complete v2 installation instructions if you’d like to try and fix it yourself.
